Guidance:

• Install fasteners with 0-2500 rpm screw gun equipped with depth sensing noise piece.
• Use of T20W drive bit is required
• Fastener length should provide for a minimum of 1” (25.4mm) penetration into wood substrate. Check with the cladding panel manufacturer for specific installation guidelines.
• Use of impact guns or hammer drills is not recommended.

Specifications:

• Fastener Length= 1”
• Application= Facade/cladding panel to wood
• Head Style=  Dome Head
• Head Diameter= 0.473"  (12.0 mm)
• Unthreaded Length= 10mm  (0.394”)
• Drive Socket=  T20W
• Product Type= Wood Screw
• Diameter= #10
• Diameter (mm)=   4.8mm
• Drill Point=  Type A
• Material=  304 Stainless Steel
• Thread Major Dia=   4.8 mm  (0.191")
• Thread Minor Dia=  3.4 mm   (0.132" )
• Threads Per Inch=   12
• Low profile drive head for aesthetically pleasing appearance.

Warranty:   

The warranty will be honored only through the manufacturer, SFS Group. For your convenience, product warranty information is attached below; please click the link below to view the current warranty policy on the manufacturer's site. If you need further assistance regarding your coverage or have other inquiries, please contact the manufacturer directly.

Email  -  [email protected]