Bullet Tools Hone Stone for Magnum and Sharpshooter

Hone Stone - for a razor edge on your blade.  Run the Hone Stone along the flat side of the shear's blade after each use. The shear will continue to perform with the same high-quality level as its first cut. With regular maintenance, a shear blade can outlast 20 saw blades.

• Keeps edge sharp for clean cuts
• Requires no fluid or oil prior to or during use
• May be used on any steel blade
• Use after each cutting job to ensure clean, accurate cuts

It is VERY IMPORTANT to hone your blade:
1. After the first 30 cuts on a new blade
2. Every 100 cuts on the job
3. When the blade has been re-sharpened

It is quick and easy to hone your blade. With the blade in the machine, press down the handle until the blade is just above the blade stop (approximately 1/8³). Then, lay the wide flat side of the hone stone against the flat side of the blade and move the hone stone from side to side 2 to 3 times to remove any burrs.